Topic : Chips 'n Chips Author : Michael Ruge Version : chips_x.hyp (01/05/2001) Subject : Dokumentation/Hardware Nodes : 1505 Index Size : 35662 HCP-Version : 3 Compiled on : Atari @charset : atarist @lang : @default : @help : @options : -i -s +zz -t4 @width : 75 View Ref-File Bei einigen TTs älterer Bauart führte eine falsche Gleichung in den PALs zur FPU-Ansteuerung zu Fehlern, die sich insbesondere in Abstürzen des ATARI TT Unix bereits während des Hochfahrens be- merkbar machen. Möglich, daß ähnliche Probleme auch unter Linux auftreten. Daher hier ein Patch, der mir damals von ATARI mitge- teilt wurde und der das Problem in der Tat beseitigt. Achtung: Dieser Patch darf nur bei der unten angegebenen Platinenrevision (betroffen sind ausschließlich die 32 MHz Daughter-Boards mit der Bezeichnung CA400771) durchgeführt werden. Andere Revisionen sind von diesem Fehler nicht betroffen. An unfortunate equation in the 16L8 PAL on the daughter card causes the PAL nach tristate AS und DS too early during bus arbi- tration. This allows AS and/or DS to float for a bit before the alternate master drives them. When the arbitration happens to occur coincident with the right kind of FPU cycle, the FPU appa- rently sees a glitch on AS or DS at the end of the cycle after they start floating but before the FPU chip select has had time to go high. Fix: Put the 16L8 PAL's pin 11 free (this is the signal 'XBG') and tie it high. This prevents the PAL from tri-stating AS and DS until XBGACK has gone low. To make your 32 MHz daughter-card work: 1) Pull pin 11 of the 16L8 PAL out of the board 2) Tie pin 11 of the IC to +5V (pin 20 of 16L8) This applies to the CA400771 32 MHz daughter board. _______________________________________________________________ ATARI 32 Meg Daughter Board / PGA | | | ___________________ | | | | | | | 2 1 1 1 1 1 1 1 1 1 | 0 9 8 7 6 5 4 3 2 1 | . . . . . . . . . . . . . . . . . . . . | PAL 16R4-7PC PAL 16L8-7PC | . . . . . . . . . . . . . . . . . . . . | 1 | 1 2 3 4 5 6 7 8 9 0 | | | CA400771 | ___________________________________________________________| | | | | | __| Kapitel Der FPU Fehler in TT030 der älteren Bauart, Seite 1