Topic       : Documentation of the CT60
Author      : Didier MEQUIGNON
Version     : Version 2.00 (December 11, 2010)
Subject     : Documentation
Nodes       : 135
Index Size  : 3664
HCP-Version : 3
Compiled on : Atari
@charset    : atarist
@lang       : 
@default    : 
@help       : 
@options    : -i
@width      : 75
View Ref-File7.1  Introduction                                                 CT60

The CT60's configuration is set with a CPX, used normally with
XCONTROL, ZCONTROL, or COPS.

This CPX allows to :

   ∙ Configure the Non Volatile Memory.

   ∙ Configure the boot in Flash Eprom.

   ∙ Measure MIPS.

   ∙ See the load of the system (MiNT or MagiC only).

   ∙ Measure the temperature of the 68060 (for overclocking) => With
     the driver CT60XBIO.PRG or the TOS in flash.

   ∙ Switch off the computer.

   ∙ See 'Informations about the SDRAM'.





There are five common buttons on this CPX :

   ∙ Save : Button for save adjustments on the disk.

   ∙ Load : Button for load adjustments saved on the disk.

   ∙ OK : Button for validate the values changed into the non
     volatile ram and the flash parameters.

   ∙ Cancel : Button for not change values to the configuration.

   ∙ i : Button for display informations (authors and SDRAM).

For check the temperature and use curves, the CPX :

   ∙ Under TOS create a desk-accessory CT60TEMP.ACC and ask to
     reboot.

   ∙ Under MiNT create the program CT60TEMP.APP and start this
     program.

   ∙ Under MagiC start a thread.

Note: On the CT63, the temperature level is to 0 (hardware wired by
Rodolphe).